Expert Insights | Gene-editing Cell For Beginners - HeLa

Home > Application > Expert Insights | Gene-editing Cell For Beginners - HeLa

Expert Insights | Gene-editing Cell For Beginners - HeLa

Expert Insights | Gene-editing Cell For Beginners - HeLa

Expert Insights | Gene-editing Cell For Beginners - HeLa

"Expert Insights For Cells" is here again! In the previous issue, we shared the gene editing tips for the challenging THP-1 cells. We will be glad if you find something valuable to you. In this issue, we will bring you more expert insights for the HeLa cells that are super friendly for gene-editing beginners. Not only are these cells easy to culture, but various transfection methods are also applicable, and the efficiency of gene editing is high.

Talking about HeLa cells, they are stars and powerful assistants in scientific research. According to PubMed, there are over 120,000 scientific papers related to HeLa cells, and they have even contributed to Nobel Prize-winning achievements in multiple fields. Genetically edited HeLa cell lines can be used in research on cancer, cancer treatment, cell death, signal pathways, and other areas. We have carefully prepared the tips for HeLa cell culture and gene editing for you. Let's move on if interested!

Cell Information

Cell Name

Hela (Human Cervical Cancer Cell Line)

Cell Morphology

Epithelial-like, adherent

Cell Culture Medium

DMEM + 10% FBS + 1% P/S;

Culture Environment

Air, 95%; CO2, 5%; 37°C

Medium Change Frequency

2-3 times/week

Passage Ratio

1:2-1:5

Cell Image (Normal Growth) - It is normal for cells to be elliptical or spindle shaped

Cell Image (Normal Growth) - It is normal for cells to be elliptical or spindle shaped

Cell Image (Poor Cell Condition)

Cell Image (Poor Cell Condition)

Cell Gene-editing Tips For HeLa

Note For HeLa Cell Transfection

1. Ensure that the cells are in good condition, in the logarithmic growth phase, with cell density generally between 80% and 90%.

2. Pay attention to the digestion time of the cells to avoid excessive digestion, which can damage the cells.

3. During the experiment, cells should be pipetted into single cells to avoid cell clumping.

4. The viability should be ≥80% when performing experiments with the cells.

5. Before using transfection reagents, ensure thorough mixing to ensure uniformity.

Note For Common Transfection Methods

Electroporation:

1. Control the amount of cells used for electroporation experiments and seed them to appropriate size of culture plates or flasks after electroporation.

2. Ensure that the cell adhesion rate is ≥70% after electroporation.

3. Control the experimental time of electroporation to avoid excessively long duration.

Lipofection:

1. Carefully control the cell confluency before transfection; it should not be too high.

2. Conduct preliminary experiments before using lipofection for formal experiments to select a suitable transfection system.

Lentiviral Transduction:

1. Carefully control the cell confluency before transduction; it should not be too high.

2. Conduct preliminary experiments before using lentiviral transduction for formal experiments to find the optimal MOI; add Polybrene before infection.

Electroporated HeLa Cells

Electroporated HeLa Cells

Lentivirus-transduced HeLa Cells

Lentivirus-transduced HeLa Cells

Note For Single-cell Cloning Of HeLa Cells

1. Ensure that the cells are in a normal condition before conducting single-cell cloning experiments, and control the cell confluency between 70% and 80%.

2. Ensure that the cell viability is ≥90% when single-cell cloning.

3. Conduct preliminary experiments to find a suitable cloning gradient to avoid a low proportion of single clones.

4. For the cell counting of the diluted cells, the best results should be between 1*10^6-2*10^6 cells/mL.

HeLa Single-cell Clone

Hela Single-cell clone

HeLa Cell Culture Protocol

Cell Thawing

1. Preparation: warm up the complete culture medium in 37°C water bath for 30 mins;

2. Inside the ultra-clean bench, pipet 7 mL of complete medium into a 15 mL centrifuge tube;

3. Take out the cryopreserved vial from dry ice, hold the cap with forceps, quickly thaw cells in a 37°C water bath by gently swirling the vial (Note: keep the cap out of the water). In about 1 minute, it would completely thaw;

4. Transfer the thawed cells to the prepared centrifuge tube (step 2) by pipette, centrifuge at 1100 rpm for 4 mins at room temp to collect the cells;

5. Prepare a new T25 flask and add 4 mL complete medium;

6. After centrifugation, carefully remove and discard the supernatant. Resuspend cell pellet with 1mL of fresh complete medium and then transfer to the prepared flask (step 5), incubate the flask in the incubator;

7. Observe the cell condition and adherent situation in the next day.

Cell Passaging (using T25)

1. As long as the cells are 80%-90% confluent, it is ready to passage. Inside the ultra-clean bench, remove and discard the medium from the flask and briefly rinse the cell 1-2 times with 5 mL PBS;

2. Add 1 mL trypsin and allow trypsin completely cover the cells, place the flask into the incubator and incubate for 1-3 mins until the majority of the cells become round and non-adherent as observed under the microscope, a large number of cells detached from each side when gently shaking and tapping the flask, terminate trypsin digestion immediately;

3. Add complete medium to stop digestion, the volume is 2 times of trypsin. Then transfer to a 15 mL centrifuge tube;

4. Centrifuge at 1100 rpm for 4 mins at room temp. After centrifugation, remove and discard the supernatant and resuspend the cells with complete medium;

5. Passage the cells at the passage ratio of 1:2-1:5, observe the cell condition in the next day of passaging.

Cell cryopreservation

1. Same as procedures of cell passaging, inside the ultra-clean bench, digest the cells to a single-cell suspension, transfer all liquid to a centrifuge tube;

2. Mix well by pipetting and take 20 μL for cell counting;

3. Centrifuge at 1100 rpm for 4 mins at room temp. After centrifugation, remove and discard the supernatant, and resuspend the cells with 1-2 mL of 4℃ pre-cooled cryopreservation medium, then add cryopreservation medium to adjust to the required density (1*10^6 cells/mL);

4. Aliquot the cell suspension to pre-labeled cryovials as 1 mL/tube;

5. Place the cryovials in 4°C pre-cooled Freezing Container, then put the container in freezers within 15 mins after cell cryopreservation;

6. Stay overnight, transfer the cryovials to liquid nitrogen for long-term storage.

Tips For HeLa Cell Culture

How to adjust if cells in poor condition:

1. Culture Medium and Serum: Ensure the correct basal culture medium is used and add an appropriate proportion of serum; serum concentration can be adjusted according to cell condition.

2. Cell Culture Environment: Confirm that temperature, humidity, and air&CO2 conditions are normal.

3. Avoid using expired or long-stored culture media. Freshly prepared complete culture media are recommended to be used within two weeks.

4. Cell Passaging and Medium Change: During cell passaging, pay attention to digestion time and trypsin concentration to avoid cell damage caused by excessively long or short digestion times; generally, perform medium changes 2-3 times per week to avoid prolonged periods without medium changes.

5. If cells are in poor condition with low cell density, re-digest the cells and seed them into smaller culture plates to achieve a cell density of at least 70%. Higher cell density promotes cell proliferation due to increased secretion of cytokines.


Ubigene Cell Bank, with 5000+ cell lines for your choices, consists of Gene KO Cells, Luciferase-expressing Cells, Cas9-expressing Cells, EGFP-expressing Cells, Wild-type Cells. STR authenticated and technical support provided.

Get the same cited cell lines

Wild-type Cell Lines

  • (Human Cervical Cancer Cell LineHela)

    Human Cervical Cancer Cell Line(Hela)

    Catalog#: YC-A012
    Size: 1*10^6
    Instruction: Human Cervical Cancer Cell LineHela
  • (Human Cervical Cancer Cell LineHela)

    Human Cervical Cancer Cell Line(Hela)

    Catalog#: YC-A012
    Size: 1*10^6
    Instruction: Human Cervical Cancer Cell LineHela

Cas9 Stable Cell Lines

Related service

According to the characteristics of different cell lines, appropriate transfection methods (virus transduction, liposome transfection, and electroporation) will be selected to transfer gRNA sequences and Cas9 protein into cells, and antibiotic screen
More details
×

Subscribe Us

By subscription, you consent to allow Ubigene Biosciences to store and process the information provided above to deliver the latest news, research spotlight, and promotions. You can unsubscribe from these communications at anytime.
×

Search documentation

Literature:

Name: *

Company: *

Telephone: *

Email:

Notes: After submitting the order, we will contact you as soon as possible.

request now
×

Search documentation

Literature:

Name: *

Company: *

Telephone: *

Email:

Notes: After submitting the order, we will contact you as soon as possible.

request now